![mtd snowblower parts-control arms mtd snowblower parts-control arms](https://images-na.ssl-images-amazon.com/images/I/61gGDeR697L._AC_SY355_.jpg)
Flat Bracket Washers Hex Nut Cupped Washer Figure 6 IMPORTANT: Attach t Do not tighten until after attaching the other end of the chute directional Lower Chute control. Secure with cupped washer (cupped side against the handle) and other hex nut. Insert eye bolt through the hole provided in the left handle. Remove any loose parts included with uniĪttaching Chute Directional Control Chute Directional Hairpin (Hardware C) Control Clip Thread one hex nut about halfway onto eye bolt on the chute directional control. Remove staples or break glue on the top flaps of the carton. Tighten the four hex bolts used to attach the bottom Unpacking of the handles to the snow thrower frame. Secure the left side of the handle panel in the same manner. SECTION 3: ASSEMBLING YOUR SNOW THROWER NOTE: Reference to right or left side of the snow washers (cupped side against handle panel) and thrower can be determined from behind the unit in the hex nuts. (Hardware pack may contain extra items which are not used on your unit.) ATTACHING THE HANDLES ATTACHING THE CHUTE ASSEMBLY A B Hex Bolts (710-3015) Hex Bolts 1/4-20 x 3/4” 5/16-18 x 1-3/4” (710-3180) Hex Bolts 5/16-18 x 3/4” Handle Tabs (710-3008) (784-5599) Lock Washers 5/16” I.D. SECTION 2: CONTENTS OF HARDWARE PACK Lay out the hardware according to the illustration for identification purposes. Never run an engine indoors or in a poorly ventilated Main
![mtd snowblower parts-control arms mtd snowblower parts-control arms](https://i.ebayimg.com/images/g/3WIAAOSwT1hhVy1h/s-l300.jpg)
Keep all safety devices in place and working. Never operate with a missing or damaged discharge of your nearest servicing dealer. telephone 1-80 for assistance and the name 4. If situations occur which are not covered in this manual, and automatically return to the disengaged position when use care and good judgment. The clutch levers must operate easily in both directions 20. WARNING: Engine Exhaust, some of its constituents, and certain vehicle componenģ. When you see this symbol - heed its warning.
![mtd snowblower parts-control arms mtd snowblower parts-control arms](https://i.ebayimg.com/images/g/jooAAOSwY-NhUwOl/s-l300.jpg)
Failure to comply with these instructions may result in personal injury.
Mtd snowblower parts control arms manual#
Read and follow all instructions in this manual before attempting to operate this machine. SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. TABLE OF CONTENTS Content Page Important Safe Operation Practices. If a spark arrester is used, it should be maintained in effective working order by the operator. OPERATOR’S MANUAL SNOW THROWER MODEL E740F IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).